I found this vanity on a local barter and trade site for $50. I’ve been looking for a vanity for a long time and bought this one to make into something I’d love and use.
The veneer had damages, but the vanity was in tack. I knew I’d first remove the veneer.
Removing the veneer.
I tried using heat to release the veneer, but found the most productive way to get it off was picking and peeling using straight edge razor and various putty knives. Not the most fun part for sure. Some peeled in strips, some areas I had to pick tiny pieces at a time. I’m sure someone has a better method, but this worked for me.
Most veneer off.
Getting down to the bare bones.
After removing all veneer, I sanded. Getting down in all the cracks and crevasses took patience. I sanded it even more after this to get the wood as fresh looking as possible. My best advise here is sand, sand, and sand some more. When you think you sanded enough, go sand it more.
I carefully stained the piece. I used a grain defining stain. Because of the variation of types of wood it gave a variation in color I was happy with. I did all the same steps with the topper that holds the mirror.
Found this stamped on the mirrors!
The stamp says “Galax Va.”, can’t read the middle, and 1942. Which I’m assuming dates the piece to 1942.
I used 4 coats of premium satin finish polyurethane. And used a little Brasso to clean the handles.
I’m so delighted with the outcome! Over 100 hours of blood, sweat, and tears.
Before and after side by side.
Please Head On Over To Next Page and don’t forget to SHARE with your Facebook friends